Host Parameters - Symbol LS4278 Reference Manual

7 - 4 Symbol LS4278 Product Reference Guide
RS-232 Host Parameters
Various RS-232 hosts are set up with their own parameter default settings
Wincor-Nixdorf Mode A, Wincor-Nixdorf Mode B, Olivetti, Omron, or terminal sets the defaults listed below.
Terminal Specific RS-232
Table 7-2
Parameter
Transmit Code ID
Data Transmission
Format
Suffix
Baud Rate
Parity
Hardware
Handshaking
Software
Handshaking
Serial Response
Time-out
Stop Bit Select
ASCII Format
Beep On <BEL>
RTS Line State
Prefix
*In the Nixdorf Mode B, if CTS is Low, scanning is disabled. When CTS is High, the user can scan bar
codes.
**If Nixdorf Mode B is scanned without the cradle connected to the proper host, the scanner may
appear unable to scan. If this happens, scan a different RS-232 host type within 5 seconds of cycling
power to the cradle.
Standar
d ICL Fujitsu
(Default)
No Yes Yes
Data as is Data/Suffix Data/
Suffix
CR/LF CR (1013) CR
(7013) (1013)
9600 9600 9600
None Even None
None RTS/CTS None
Option 3
None None None
2 sec. 9.9 sec. 2 sec.
One One One
8-Bit 8-Bit 8-Bit
Disable Disable Disable
Low High Low
None None None
(Table 7-2). Selecting the ICL, Fujitsu,
Wincor-
Wincor-
Nixdorf
Nixdorf
Mode
Mode A
B/OPOS
Yes Yes
Data/ Data/Suffix
Suffix
CR (1013) CR (1013)
9600 9600
Odd Odd
RTS/CTS RTS/CTS
Option 3 Option 3
None None
9.9 sec. 9.9 sec.
One One
8-Bit 8-Bit
Disable Disable
Low Low = No
data to send
None None
Olivetti Omron
Yes Yes
Prefix/Data/ Data/Suffix
Suffix
ETX (1002) CR (1013)
9600 9600
Even None
None None
Ack/Nak None
9.9 sec. 9.9 sec.
One One
7-Bit 8-Bit
Disable Disable
Low High
STX (1003) None