Rs-232 Host Parameters - Symbol LS 7708 Product Reference Manual

RS-232 Host Parameters

Various RS-232 hosts are set up with their own parameter default settings. Selecting the ICL, Fujitsu, Wincor-Nixdorf Mode A,
Wincor-Nixdorf Mode B, Olivetti, Omron, or terminal sets the defaults listed in
Parameter
Transmit Code ID
Data Transmission
Format
Suffix
Baud Rate
Parity
Hardware
Handshaking
Software
Handshaking
Serial Response
Time-out
Stop Bit Select
ASCII Format
Beep On <BEL>
RTS Line State
Prefix
*In the Nixdorf Mode B, if CTS is Low, scanning is disabled. When CTS is High, the user can scan bar codes.
**If Nixdorf Mode B is scanned without the scanner connected to the proper host, it may appear unable to scan. If this
happens, scan a different RS-232 host type within 5 seconds of cycling power to the scanner.
Table 6-2. Terminal Specific RS-232
Standard
(Default) ICL Fujitsu
No Yes Yes
Data as is Data/Suffix Data/Suffix
CR/LF CR (1013) CR (1013)
(7013)
9600 9600 9600
None Even None
None RTS/CTS None
Option 3
None None None
2 Sec. 9.9 Sec. 2 Sec.
One One One
8-Bit 8-Bit 8-Bit
Disable Disable Disable
Low High Low
None None None
Table 6-2.
Wincor- Wincor-
Nixdorf Nixdorf
Mode A Mode B/OPOS Olivetti
Yes Yes Yes
Data/Suffix Data/Suffix Prefix/Data/
Suffix
CR (1013) CR (1013) ETX (1002)
9600 9600 9600
Odd Odd Even
RTS/CTS RTS/CTS None
Option 3 Option 3
None None Ack/Nak
9.9 Sec. 9.9 Sec. 9.9 Sec.
One One One
8-Bit 8-Bit 7-Bit
Disable Disable Disable
Low Low = No data Low
to send
None None STX (1003)
RS-232 Host Interface 6-7
Omron
Yes
Data/Suffix
CR (1013)
9600
None
None
None
9.9 Sec.
One
8-Bit
Disable
High
None