Beep On Insertion; Intellistand Idle Timeout - Symbol LS4278 Reference Manual

Beep on Insertion

When a scanner is inserted into a cradle and detects power, it emits a short low beep. This feature is enabled by
default.
To enable or disable beeping on insertion, scan the appropriate bar code below.
*
Enable Beep on Insertion

Intellistand Idle Timeout

While in Intellistand, the scanner enters low power mode when no bar code is decoded within 15 minutes. In the
stand, this low power mode is called Intellistand Idle Timeout.
The default Intellistand idle timeout is 15 minutes. The Intellistand idle timeout can be set to the following intervals:
•
5 minutes
•
10 minutes
•
15 minutes (default)
•
30 minutes
•
1 hour
•
2 hours.
NOTE When the scanner enters Intellistand Idle Timeout (low power mode in the stand), scanning capability
suspends. To restart scanning capability, press the trigger or remove the scanner and replace it into the
stand.
Scan a bar code below to set the Intellistand idle timeout interval.
User Preferences
Disable Beep on Insertion
5 - 5