Attach Seat - Razor Scream Machine Jr Owner's Manual

NOTE: The steering bushings are designed for long life and
should require no maintenance. They do not require oil or any type of
"wet" lubrication. If the steering becomes rough, disassemble, inspect
and clean the bearing surfaces (soap and water is fine). Dry thoroughly
and reassemble. Although the bushings and thrust washers are self-
lubricating, a light application of a dry-lube can be used to facilitate the
anti-friction properties of the steering head bushings.
NOTE: Although we make every effort to keep our manual up-to-
date, if your Scream Machine does not look like this, then we've made
improvements since this document was printed. Check out the Razor
website: www.razor.com for technical updates on the latest service and
adjustment procedures. For example: later models do not have the
spacer between the fork crown and the adjusting cap as shown in 7f
and 7g.
WARNING: Failure to properly install the handlebar to the fork
legs can result in the handlebars falling off and causing risk of injury.
Periodically check to make certain the adjsuting screw is properly
tensioned and that the handlebars are securely attached to the forks.
Refer to the safety information in chapter 5 for additional details.
6D. Attach the seat.
Flip the Scream Machine on it's side and, using the screws provided
and two allen keys, fasten the seat to the frame using one of the three
positions: forward, middle and aft, depending on the rider's size.
Figure 7g. Snug the adjusting screw.
11