Teledyne 4700 Serivce Manual page 107

4700 Refrigerated Sampler Service Guide
Note
Before connecting, route these wires under those of the com-
pressor cord, as shown in Figure 4-16, to prevent them from
being caught under the edge of the protective cover.
3. Ensure that the gasket in the cover is evenly seated in its
groove. Align the cover over the eight mounting holes and
reattach it with the self-tapping torx screws.
When reinstalling all self-tapping screws, avoid destroying the
plastic threads. First seat each screw in its hole and, without
pressing down, rotate the screw counter-clockwise until it falls
into its thread groove with a "click." Then tighten the screw.
4. Reinstall the power supply, following the instructions in
Section 4.5.4.
5. Close the rear compartment (see Section 1.9 Closing the
Rear Compartment).
Section 4 CPU and Power Supply
CAUTION
4-25