Checking The Programmed Water Hardness - Miele G 641 SCi Operating Instructions Manual

Before using for the first time
^ Press the "Start" button.
The "Start" indicator will light.
^ Turn the program selector to "Stop".
^ Turn off the dishwasher with the
"On/Off" button.
The programmed water hardness is
stored.
16
Checking the programmed water
hardness
^ Make sure the dishwasher is turned
off.
^ Turn the program selector to "Stop".
^ Press and hold the "Start" button and
at the same time turn on the dish-
washer with the "On/Off" button. Re-
lease the "Start" button within two
seconds.
The "Salt" indicator will flash.
If the "Rinse aid" indicator comes on,
the rinse aid dispenser needs to be
filled.
If any other indicator is lit or flashing,
the above steps must be repeated.
^ Turn the program selector clockwise
until the "Start" indicator comes on.
The position where the "Start" indicator
comes on corresponds to the pro-
grammed water hardness (see table
"Programming the water softener").
^ Turn the program selector to "Stop".
^ Turn off the dishwasher.