Location & Rough-In Dimensions; Remove Access Panel - Whirlpool Undercounter Dishwasher Installation Instructions Manual

Location & Rough-in Dimensions
Remove Access Panel
When determining location, consider the accessibil-
ity to the existing service lines. Also plan to place
your dishwasher where its water inlet valve is pro
tected from freezing. It is recommended that a built-
in dishwasher be installed on either side of and ad-
jacent to the kitchen sink. This area is readily access-
sible to plumbing facilities and convenient for load-
ing. Minimum height needed for installation of this
dishwasher is 34-l/4".
NOTE:
If leveling is required, dishwasher should be
leveled before the drain, water and electrical lines
are connected.
IMPORTANT:
Squareness of opening is im-
portant for proper dishwasher operation and
appearance. It is also important that the cab-
inet front is perpendicular to the floor. Be
sure you are locating your dishwasher where
you have access to water, electricity and
drainage.
LEVELING
ACCESS PANEL
)
SCREW
Remove the 4 screws that attach
the access panel to the
dishwasher legs.
See Figure 3.
4