Whirlpool Undercounter Dishwasher Installation Instructions Manual page 13

Installation and Operation
l
. .
Double Check I/ I/
0 Securely fastened in place.
0 Water supply valve turned on.
0 Checked out for leaks at joints.
\
0 Wire connections tight, water inlet valve wiring in place.
0 Make certain electricity is turned on.
@
0 No kinks in water or drain lines.
1
0 Recheck the removal of packing material and Customer Literature
Package from interior of dishwasher.
-4-q
6-T .
3
0 Spin spray arms to check movement.
7,
0 Start dishwasher.
0 Check water
level . . . water should fill to the round heater element.
0 Check for complete drain . .
no water should be visible above
grate when drain is complete.
0 Check for leaks . . . particularly around door, pump mounting
gasket, and at hose connections. Also the plumbing connection
at the water inlet valve.
NOTE TO INSTALLER: Put Installation Instruction back in Literature Package and
place
inside dishwasher so that all information will be readily available to the user.
Adjust Door Springs and Install Access Panel
(Less tension)
(More tension)
Dishwasher leg
After dishwasher has been secured in the cabinet opening, check
door for proper operation. If adjustment is necessary, close
door and adjust door springs with pliers so door closes easily
without slamming and stays open with its own weight. See
Figure 12. Install the access panel by using the 4 screws that
were removed (2 screws on each end).
13