Table of Contents
Advertisement
Antennas
Two antennas are secured to chassis – one on the front, one on the back. You must remove all other
components to remove the antennas.
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the front fan
4.
Remove the drive cage
5.
Remove the fiber NIC assembly
6.
Remove the heat sink
7.
Remove the system board
8.
Remove the rear fan
9.
To remove the front antenna, from the inside of the front of the chassis, remove the antenna from
the clips built into the base pan.
10.
From the outside of the front of the chassis, remove the two Torx T8 screws (1) that secure the
antenna to the chassis.
(Preparation for disassembly on page
(Access panel on page
(Front fan on page
25).
(Drive cage (fiber NIC assembly holder) on page
(Installing the fiber NIC assembly on page
(Heat sink on page
27).
(System board on page
(Rear fan on page
47).
18).
44).
17).
34).
37).
Antennas
49
Advertisement
Table of Contents
Troubleshooting
