Insert Editing - JVC GR-FX36ED Instructions Manual

38
EN
COUNTER R/M Button
Power Switch
Display
w
M – 0 : 1 2 : 3 4
Remote sensor
START/STOP
REW
PLAY
STOP
USING THE REMOTE CONTROL UNIT

Insert editing

indicator
Tape Counter
INSERT
PAUSE
Insert Editing
You can record a new scene onto a previously recorded
tape, replacing a section of the original recording with
minimal picture distortion at the in- and out-points. The
original audio remains unchanged.
NOTE:
Use the remote control unit to perform this procedure.
1
Set the Power Switch to "
2
Play back the tape, locate the Edit-Out point and
press PAUSE (6).
3
Press and hold COUNTER R/M on the camcorder for
more than 1 second to reset the tape counter, then
press it again for less than 1 second so that "M"
appears.
4
Press REW (2) to go a little beyond the beginning of
the scene you want to replace, press PLAY (4) to
view the recorded tape, and press PAUSE (6) exactly
at the Edit-In point where the new scene should start.
5
Press and hold INSERT (w), and without releasing
INSERT (w), press and release PAUSE (6). The Insert
Editing indicator appears and the Insert Editing mode
is engaged. When the scene the camcorder is aimed
at appears on the screen, go to the next step.
6
To begin Insert Editing, press START/STOP. When the
counter reaches "0:00:00", editing stops automati-
cally and the camcorder enters the Insert-Pause
mode.
7
To end Insert Editing, press STOP (5).
NOTES:
During Insert Editing, the original audio will be heard
from the speaker.
After step 5, Retake (
The tape may stop slightly before or after the designated
end point, and noise bars may appear. Neither indicates
a defect in the unit.
Only the video signal is recorded in the Insert Editing
mode.
(cont.)
".
pg. 17) can be performed.