Daily Use - IKEA Lagan HGA4K Instruction Manual

ENGLISH

Daily use

Warning! Refer to Safety
chapters.
Burner overview
Burner cap
1
Burner crown
2
Ignition candle
3
Injector
4
Thermocouple
5
Ignition of the burner
Always ignite the burner before
positioning pots or pans
To ignite the burner:
1. Push the electric ignition button witch is
marked by a little spark
time turn the relevant control knob
anticlockwise to maximum position
2. Keep the knob pushed for about 5 sec;
this will allow thermocouple to heat up,
and the safety device to switch off,
otherwise the gas supply would be
interrupted.
3. After the flame is regular, adjust it as
preferred.
1
2
3
4
5
, at the same
.
If after a few attempts the burner
does not ignite, check that the
crown and its cap are in correct
positions.
Warning! Do not keep control
knob pressed for more than 15
seconds. If the burner does not
light after 15 seconds, release
the control knob, turn it into off
position and wait for at least 1
minute before trying to light the
burner again.
In the absence of electricity you
can ignite the burner without
electrical device; in this case
approach the burner with a
flame, push the relevant knob
down and turn it counter-
clockwise to maximum gas
release position.
Warning! Maintain extreme
caution while operating with
open fire in kitchen environment.
Manufacturer declines any
responsibility in case of misuse of
flame.
If the burner accidentally goes
out, turn the control knob to the
off position and wait for at least
1 minute before trying to light it
again.
When switching on the mains,
after installation or a power cut,
it is quite normal for the spark
generator to be activated
automatically.
9