Camera Pan/Tilt Setup - Honeywell HNDR series User Manual

6. Camera Pan/Tilt Setup

7
[PTZ Protocol Setup]
1
• Use PTZ: Check to use the PTZ camera.
• PTZ type: Select the type of receiver or camera used for the PTZ device.
• Port: Specify the serial port connected to the computer. (Specify COM 1 Port.)
• Speed: Specify the speed of PTZ device. (varies depending on the device.)
• Parity, data bit, stop bit : Specify in accordance with the manual for PTZ device.
• Following example is for only when Honeywell equipment are used
( HRX-1000, HRX-2000, HSD-251, HSDN-251, GC-655/755 ).
* PTZ type: HRX-1000, HRX-2000, HSD-251, HSDN-251, GC-655/755
* Port: COM1, * Speed: 9600, * Parity: NONE, * Data bit: 8, * Stop bit: 1
[Communication connection]
2
• Open / Close : Allows you to connect start port and stop port.
3 [Speed setup]
• P/T, F/Z, A.P : Allows you to control speed of Pan/Tilt ,Focus/Zoom and Auto pan.
4 [Auto Scan/Preset setup]
•
Auto scan: Allow you to control start point of Auto scan and stop point
( Press the "Camera menu" button and "Auto scan" button to enable setup .=> HSDN-251 )
• Preset : Allow you to control preset (1 ~10 )
( Press the "Preset setup" , move preset position and press the preset No.(1~10) to enable setup )
5 [P/T , Z/F Direction Control]
• Pan/Tilt, Zoom/Focus, and direction change (Up/ Right Up/ Right/ Right Down/ Down/ Left Down
/ Left/ Left Up) are available.
6 [Camera menu setup]
• Allow you PTZ camera menu to setup. ( Preset, Auto scan and Tour to enable setup. =>HSDN-251)
7 [Select All]
• If click this, Every of settings in "Pan/Tilt " becomes same as for all of camera.
• This button is effective when all of settings for all camera shall be same as setting in No. 1 camera.
6
5
1
2
3
4
36