Camera Motion/Image Setup - Honeywell HNDR series User Manual

5. Camera Motion/Image Setup

5
1
[Motion detection area setting]
• Whole area: Select to monitor motion in all areas covered by the camera.
• Partial area: Allows you to monitor motion in specific areas by pressing the "Add" button and
specify specific regions.
You may specify up to 20 areas, and erase them by pressing "Delete."
• Display detected area: Select and click the "Detection test" button to start monitoring the motions
when it occurs. ("Detection display" indicates that motion is detected with color change and red
dots.)
2
[Relay options]
Relay options are applicable to motion detection only.
• Use Relay: Select to use relay output
• Ports 1~4: Select all the devices to use.
• Latch time: Relay output operate during the specified time when a motion occurs.
[Color control]
3
• Brightness / Contrast / Saturation / Hue: allows you to adjust color of images.
• Default value: resets the control settings of all images to default values.
[Motion setting]
4
• Sensitivity adjustment
Allows you to adjust the rate of motion (volume). The large percentage (%) is, the subtler motion
the camera can detect, that is, the recording data increases.
• Rate of motion
Allows you to adjust color and sensitivity of a moving object. The large percentage (%) is, the
subtler difference of a moving object and the surrounding color the camera can detect, that is, the
recording data increases.
• You may decide the motion settings by clicking "Detection test" with various motion area and
viewing the displayed movement of a motion in Dot units on the screen.
5
[Select All]
• If click this, Every of settings in "Color & Motion" becomes same as for all of camera.
• This button is effective when all of settings for all camera shall be same as setting in No. X
1
2
3
4
35