Bulb Replacement; Replacing A Bulb; Interior Light - Tesla Roadster 2 Owner's Manual

Replacing a bulb

Bulb replacement

Always check the operation of all exterior
lights before driving the vehicle. Replace a
bulb only with one of the same type and
specification.
Light Emitting Diode (LED) lights
The following lights on your vehicle use the
latest LED technology and if any of these
lights stop working, it must be replaced by
Tesla Motors:
• Front side marker light
• Rear side marker light
• Reverse lights
• Tail/brake lights
• Rear turn signals
Unlike traditional filament bulbs, these lights
have a long life and low power consumption
while providing the same amount of
illumination.
Filament bulbs
The lights shown in the illustration and listed
below have replaceable filaments that should
be replaced by Tesla Motors:
• Front turn signal (1)
• Front side (2)
• Headlight high beam (3)
• Headlight low beam (4)
Roadside emergencies
1 2 3 1 2 3 4 4
TR0163
Location Watts Type
Front turn signal (1) 21
Front side (2)
Headlight high beam (3) 65
Headlight low beam (4) 60
Owner replaceable bulbs
The interior light, trunk light, and license plate
lights are easy to replace. To replace these
lights, refer to the following table and
instructions.
Location Watts Type
Interior
Trunk
License plate

Bulb replacement

TR0170

Interior light

To remove the bulb:
PY21W
1. Using the screwdriver supplied in the
5 W5W
toolkit, depress the retaining clips and
carefully pry the light unit from the rear
H9B
header rail.
2. Rotate the bulb holder 90°
HB3A
counterclockwise and remove.
3. Pull the bulb from the holder.
To install the new bulb, reverse the above
steps.
5 W5W
5 C5W
5 C5W
9-9