Fade/Wipe Effects - JVC GR-DVL520 Instructions Manual

38
EN
IMPORTANT
Some Fade/Wipe Effects cannot be used with certain
modes of Program AE with special effects (
37). If an unusable Fade/Wipe Effect is selected, its
indicator blinks or goes out.
Lock Button
MENU/BRIGHT Wheel
Power Switch
Recording
Start/Stop
Button
VIDEO/MEMORY Switch
(GR-DVL720/DVL520 only;
open the LCD monitor to
access this switch)

Fade/Wipe Effects

These effects let you make pro-style scene
pg. 36,
transitions. Use them to spice up the transition from
one scene to the next.
Fade or Wipe works when tape recording is started
or when you stop recording.
1
Set the VIDEO/MEMORY Switch to "VIDEO"
(GR-DVL720/DVL520 only), then set the Power
Switch to "
Button located on the switch.
2
Press the MENU/BRIGHT wheel in. The Menu
Screen appears.
3
Rotate the MENU/BRIGHT wheel to select "
WIPE/FADER", then press it.
4
Rotate the MENU/BRIGHT wheel to select the
desired function, then press it. Selection is complete.
Press the MENU/BRIGHT wheel in again.
• The WIPE/FADER Menu disappears and the effect
is reserved. The indicator representing the selected
effect appears.
5
Press the Recording Start/Stop Button to activate
the Fade-in/out or Wipe-in/out.
To Deactivate The Selected Effect . . .
..... select "OFF" in step 4.
NOTE:
You can extend the length of a Fade or Wipe by pressing
and holding the Recording Start/Stop Button.
FOR RECORDING
" while pressing down the Lock
(cont.)