User Maintenance; [Battery Release] - JVC GR-DVL20 Instructions Manual

54
EN
After Use
1
Turn off the camcorder.
2
Press PUSH OPEN and open the LCD monitor.
Slide OPEN/EJECT in the direction of the arrow,
then swing the cassette cover open until it locks.
The cassette holder opens automatically.
Remove the cassette.
3
Press "PUSH HERE" to close the cassette holder,
then close the cassette cover.
4
Close and lock the LCD monitor.
5
Slide BATTERY RELEASE and remove the battery
pack.
6
Replace the lens cap over the lens.
PUSH OPEN Button
Cassette holder
BATTERY RELEASE Switch
OPEN/EJECT Switch
PUSH HERE
Remove.

USER MAINTENANCE

Cleaning The Camcorder
1
To clean the exterior, wipe gently with a soft
cloth.
Put the cloth in diluted mild soap and wring it
well to wipe off heavy dirt. Then wipe again
with a dry cloth.
2
Open the LCD monitor and wipe gently with a
soft cloth. Be careful not to damage the
monitor. Close the LCD monitor.
3
To clean the lens, blow it with a blower brush,
then wipe gently with lens cleaning paper.
4
To clean the viewfinder, raise it to the vertical
position. Carefully lift the plastic tab on the
bottom of the viewfinder, and open the cover
1
.
5
Insert a lens blower or soft cloth into the gap at
the bottom of the viewfinder and clean the
interior of the viewfinder with it
6
Replace the lens cap, making sure it locks in
place. Tilt the viewfinder back to the horizontal
position.
NOTES:
Avoid using strong cleaning agents such as benzine
or alcohol.
Cleaning should be done only after the battery
pack has been removed or other power units have
been disconnected.
Mould may form if the lens is left dirty.
When using a cleaner or chemically treated cloth
refer to the cautions of each product.
Bottom of viewfinder
Blower brush
2
1
Cover
2
.