JVC GR-DVL20 Instructions Manual page 20

20
EN
Date/Time Menu Explanations
INDICATION
ON SCREEN *
DISPLAY
DATE/TIME
* You can also change "ON SCREEN" to "ON" or "OFF" by pressing the DISPLAY button on the RM-V711U
remote control.
System Menu Explanations
TELE MACRO
WIND CUT
SOUND MODE
ID NUMBER
DEMO. MODE
: Factory preset
Makes all the indications appear in the camcorder (
ON
Keeps all the indications (except the tape running indicator, warnings,
OFF
etc.) from appearing in the camcorder (
Keeps the camcorder's display from appearing on the connected TV
OFF
screen.
ON Makes the camcorder's display appear on screen when the camcorder is
connected to a TV.
Makes the date/time settings appear in the camcorder (
ON
Keeps the date/time settings from appearing in the camcorder.
OFF
Allows you to set the current date and time (
Usually the distance to a subject where the lens is in focus depends on
OFF
the zoom magnification. Unless there is a distance more than 1m to the
subject, the lens is out of focus at the maximum telephoto setting. When
set to "ON", you can shoot a subject as large as possible at a distance of
ON
approx. 60 cm.
•Depending on the zoom position, the lens may go out of focus.
Disengages the function which cuts down on noise created by wind.
OFF
Helps cut down on noise created by wind.
ON
•" " appears.
•The quality of the sound will change. This is normal.
Enables recording of stereo sound on four separate channels, and is
32 kHz
recommended for use when performing audio dubbing.
Enables recording of stereo sound on two separate channels.
48 kHz
This number is necessary when connecting the camcorder to a device such as a
computer using the J terminal (JLIP). The numbers range from 01 to 99. Factory setting
is 06.
Automatic demonstration will not take place.
OFF
Demonstrates certain functions such as Programme AE with special
ON
effects, etc., and can be used to confirm how these functions operate.
When "DEMO. MODE" is set to "ON" and the Recording Menu is
closed, demonstration starts.
NOTES:
If a tape is in the camcorder, the demonstration cannot be turned on.
By turning off the camcorder, "DEMO. MODE" is set to "OFF"
automatically.
RECORDING
pg. 8).
Advanced Features (cont.)
pg. 21).
pg. 21).
pg. 21).