C3G124-24P Stackable Switch - Enterasys SecureStack C3G124-24P Installation Manual

Overview
• Four SFP slots that provide you with the option of installing Small Form Pluggable
(SFP) Mini‐GBICs for 1000BASE‐SX/LX fiber‐optic connections and 1000BASE‐T
copper connections.
• Rear panel connectors for high‐speed connections in a stack configuration.
• Rear panel Redundant Power Supply connector used to connect to a SecureStack
PoE‐compliant Redundant Power Supply (C2RPS‐POE). The switch connects to the
SecureStack C2RPS‐POE using a SecureStack C2RPS‐POE cable.
The 10/100/1000 Mbps fixed front panel ports can operate in either half‐duplex or full‐
duplex mode, as determined by Auto‐Negotiation.
Figure 1-1
1 DB9 RS232 console port connector
2 System status LEDs
3 Twenty-four RJ45, 10/100/1000 Mbps, PoE ports
4 RJ45 port status LED
5 Four slots for SFP interface modules
(Mini-GBICs)
1-2 Introduction
Note: The Mini-GBIC ports cannot be active simultaneously with their corresponding
10/100/1000BASE-T ports. For example, if SFP port 24 establishes a link first on the
C3G124-24P, the 10/100/1000BASE-T built-in RJ45 port 24 is not available and
vice-versa.
Caution: The C3G124-24P and C3G124-48P are PoE-compliant devices. Do not connect
a SecureStack Redundant Power System (C2RPS-SYS) to the power connector.
Otherwise, damage to the device may result.
Precaución: Los dispositivos C3G124-24P y C3G124-48P cumplen con el estándar PoE
(power over ethernet). No conecte una fuente de poder redundante (RPS) SecureStack
(C2RPS-SYS) al cable de corriente. De lo contrario, el dispositivo puede dañarse.

C3G124-24P Stackable Switch

S
6 Mini-GBIC port status LEDs
7 Two ports for stack connections
8 Password Reset switch
9 AC power input connector
10 RPS connector for SecureStack PoE
redundant power supply connection
C3G124-24P