Chassis Bottom, Rubber Feet Placement - Enterasys SecureStack C3G124-24P Installation Manual

Figure 3-3

Chassis Bottom, Rubber Feet Placement

Á
Â
Â
1 Bottom of chassis as seen when chassis is
resting on its back
2 Locations to install the rubber feet (four locations)
4. Remove the protective strip from the back of one rubber foot and position it on a
marked location and press firmly into place. Repeat this procedure to install the
remaining three rubber feet.
5. After installing the rubber feet, return the switch to its upright position.
Note: If a number of switches are being installed in a stack, repeat steps 1 through 4 to
install the rubber feet on each switch before continuing with the installation.
6. To install switches on a flat surface, proceed to "Guidelines for Flat Surface
Installation" on page
the Switch" on page 3‐9.
À
3‐8. For a rackmount installation, proceed to "Rack Mounting
Installing the Switch on a Flat Surface
Â
Â
3 Rubber feet with adhesive backing
(four)
SecureStack C3 Installation Guide 3-7