Step 4 - Attach Wiring To Removable Locking Connector - OWI ICM6-730SET Installation Manual

High output ceiling speakers

Hide thumbs Also See for ICM6-730SET:

Table of Contents

INSTALLATION AND WIRING

Using an Alternate Fitting

relief fitting accommodates many common fitting

requirements. Sometimes, alternate fittings are

required, such as for larger diameter conduit or to

meet specific code requirements.

In these cases, the existing fitting can be easily

replaced with a number of available off-the-shelf

fittings. Simply remove the existing fitting by

unscrewing the two hold-down screws, exposing a

7/8 inch (22mm) knockout hole. Then, install the

alternate fitting.

Step 4 – Attach Wiring to the Removable Locking Connector

Connect the end of the wiring to the removable locking connector that is included with

the speaker by stripping the insulation back about 5mm, inserting the bare end of the wire

into the connector and screwing down the holddown screw until tight. Tighten any

unused screws to avoid vibration.

OWI INC. ICM6-730SET (All-N-One) CEILING SPEAKERS – INSTALLATION GUIDE

– the existing strain

CAUTION:

ALWAYS USE THE

PROPER FITTING

IN ACCORDANCE

WITH YOUR

AREA'S BUILDING

CODES AND

REGULATIONS

Table of Contents