Step 3 - Expose The Input -Terminal - OWI ICM6-730SET Installation Manual

High output ceiling speakers

Hide thumbs Also See for ICM6-730SET:

Table of Contents

INSTALLATION AND WIRING

Step 3 – Expose the input-terminal on the rear of the speaker

Remove the rear cover plate, complete with wire strain relief, by loosing the two screws

holding it in place, and sliding the plate off. Once the cover is removed, open the strain

relief fitting by loosening the horizontal screws.

Run the speaker wires through the strain relief opening. After passing about 4 to 6 inches

of wire through the fitting, tighten the screws on the strain relief to secure the fitting and

back plate to the speaker wire. DO NOT over tighten or you may damage the wire jacket,

a snug fit is all that is required.

Tightening onto flexible or hard conduit - The supplied fitting accommodates up to 3/8

inch (9.5mm) flexible conduit. Insert the conduit into the strain relief fitting. Using the

two horizontal screws that clamp the fitting together, clamp the conduit securely between

them. Be sure to leave at least 4 to 6 inches of cable beneath the strain relief fitting.

OWI INC. ICM6-730SET (All-N-One) CEILING SPEAKERS – INSTALLATION GUIDE

Table of Contents