Table of Contents
Advertisement
INSTALLATION AND WIRING
Daisy-chain Wiring (Using Loop-Through Terminals - Pins 1 & 4):
To daisy-chain the wiring, connect the wire pair of the follow-on speaker to pins 1 and 4.
Figure 10 – Daisy-chain wiring
Step 5 – Plug connector into connector socket
With all wiring to the connector completed, plug the connector into the socket in the
speaker's terminal cup. Remember to tighten any loose screws to eliminate any vibration.
Slip the input terminal cover back onto the rear of the speaker and tighten the two screws
that keep it in place.
OWI INC. ICM6-730SET (All-N-One) CEILING SPEAKERS – INSTALLATION GUIDE
DAISY CHAIN WIRING
By connecting the wire pair of
the subsequent speaker to pins 1
& 4, then all subsequent
speakers will be disconnected
when this speaker's connector is
disconnected during
troubleshooting. This can be a
useful way to isolate problems
to a section of the distributed
line while leaving the wires
attached to the connector.
Figure 11 - Plug connector into
connector socket
8
Advertisement
Table of Contents
