JVC GR-D372U Instructions Manual page 44

TROUBLESHOOTING
44
EN
Warning Indications
Displays the battery remaining power.
Remaining power level
High
As the battery power comes close to nil, the
battery remaining power indicator blinks.
When the battery power is exhausted, power
turns off automatically.
Appears if a tape is loaded.
Blinks when no tape is loaded.
CHECK TAPE'S ERASE PROTECTION TAB
Appears when the erase protection tab is set to
"SAVE" while the Power Switch is set to "REC"
and the VIDEO/MEMORY Switch is set to
"VIDEO". ( pg. 15)
USE CLEANING CASSETTE
Appears if dirt is detected on the heads during
recording. Use an optional cleaning cassette.
( pg. 48)
CONDENSATION, OPERATION
PAUSED PLEASE WAIT
Appears if condensation occurs. When this
indication is displayed, wait more than 1 hour
until condensation disappears.
TAPE!
Appears if a tape is not loaded when the
Recording Start/Stop Button or SNAPSHOT
Button is pressed while the Power Switch is set
to "REC" and the VIDEO/MEMORY Switch is set
to "VIDEO".
TAPE END
Appears when the tape ends during recording or
playback.
SET DATE/TIME!
Appears when the date/time is not set.
( pg. 16)
The built-in clock battery has run out and the
previously set date/time has been erased.
Consult your nearest JVC dealer for
replacement.
LENS CAP
Appears for 5 seconds after power is turned on if
the lens cap is attached or when it is dark.
MEMORY IS FULL
Appears when the memory card's memory is full
Exhausted
and shooting is not possible.
HDV
Appears when pictures recorded in the HDV
format are detected. The pictures in the HDV
format cannot be played back with this
camcorder.
?
Appears when playing back a file that is not
compatible with DCF or a file with a size that is
not compatible with this camcorder.
COPY PROTECTED
Appears if dubbing of copyguarded signals is
attempted while this camcorder is being used as
a recorder.
MEMORY CARD!
Appears if there is no memory card loaded when
the SNAPSHOT Button is pressed while the
Power Switch is set to "REC" and the VIDEO/
MEMORY Switch is set to "MEMORY".
PLEASE FORMAT
Appears when there is a problem with a memory
card and its memory is corrupt, or it has not
been initialized. Initialize the memory card.
( pg. 28)
NO IMAGES STORED
Appears if there are no image files stored in the
memory card when you attempt memory card
playback.
CARD ERROR!
Appears when the camcorder does not
recognize the loaded memory card. Remove the
memory card once and insert it again. Repeat
these procedures until no indication appears. If
the indication still appears, the memory card is
corrupted.