Shoulder Strap Attachment; Tripod Mounting; Loading/Unloading A Cassette - JVC GR-D20 Instructions Manual

Jvc digital video camera instructions
Hide thumbs Also See for GR-D20:
Table of Contents

Advertisement

Shoulder Strap Attachment

1
Thread the strap through the eyelet
back and thread it through the buckle. Repeat the
procedure to attach the other end of the strap to the
e
other eyelet
located under the Grip Strap. Confirm
the strap is not twisted.
e

Tripod Mounting

CAUTION
When attaching the camcorder to a tripod, extend its
legs to stabilise the camcorder. It is not advised to use
small sized tripods. This may cause damage to the unit
by falling over.
1
To attach the camcorder to a tripod, align the
direction stud and screw to the stud hole
i
mounting socket
on the camcorder. Then tighten the
screw clockwise. Some tripods are not equipped with
studs.
The camcorder needs to be powered up to load or eject
e
, then fold it
a cassette.
1
Slide and hold OPEN/EJECT
the arrow then pull the cassette holder cover open until
it locks. The cassette holder opens automatically.
• Do not touch internal components.
2
Insert or remove a tape and press "PUSH HERE" to
close the cassette holder.
• Once the cassette holder is closed, it recedes
automatically. Wait until it recedes completely before
closing the cassette holder cover.
• When the battery's charge is low, you may not be able
to close the cassette holder cover. Do not apply force.
Replace the battery with a fully charged one before
continuing.
3
Close the cassette holder cover firmly until it locks
into place.
To Protect Valuable Recordings:
Slide the erase protection tab on the back of the
tape in the direction of "SAVE". This prevents the
tape from being recorded over. To record on this
tape, slide the tab back to "REC" before loading it.
u
and
i
u
Be sure to press only the section labeled "PUSH
HERE" to close the cassette holder; touching other
parts may cause your finger to get caught in the
cassette holder, resulting in injury or product damage.
Approximate recording time
30 min.
60 min.
80 min.
NOTES:
The cassette holder cannot be opened unless a power
supply is attached.

Loading/Unloading A Cassette

Q
Recording mode
Tape
SP
30 min.
60 min.
80 min.
Q
in the direction of
Make sure the
window side
is facing out.
Cassette holder
Cassette
holder
cover
LP
45 min.
90 min.
120 min.
Continued on next page.
EN
9
GETTING STARTED

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents