Checking Rear Brake Linings; Removing Rear Brake Linings; Installing The Rear Brake Linings - KTM 50 SX Owner's Manual
Ktm 50 sx series motorcycles owner's manual
Hide thumbs
Also See for 50 SX:
- Repair manual (159 pages) ,
- Owner's manual (91 pages) ,
- Setup instructions (19 pages)
Table of Contents
Advertisement
MAINTENANCE WORK ON CHASSIS AND ENGINE
Checking rear brake linings
9.51
Warning
Danger of accidents Reduced braking due to worn brake linings.
–
Worn brake linings should be replaced immediately in an authorized KTM workshop.
Removing rear brake linings
9.52
Warning
Danger of accidents Improper brake maintenance and repair.
–
Always have your brake system maintained and repaired in an authorized KTM workshop.
Installing the rear brake linings
9.53
Warning
Danger of accidents Reduced braking due to oil or grease on the brake discs.
–
Always keep the brake discs free of oil and grease, and clean them with brake cleaner when necessary.
Warning
Danger of accidents Reduced braking due to use of non-approved brake linings.
–
Brake linings available from accessory suppliers are often not tested and approved for use on KTM vehicles. The construc-
tion and friction factor of the brake linings and therefore the brake power can differ considerably from the original KTM
brake linings. If brake linings are used that differ from the originals, there is no guarantee that they comply with the origi-
nal license. The vehicle no longer corresponds to the condition at delivery, and the warranty is no longer valid.
–
Check the brake linings for minimum thickness
Minimum thickness
»
If the minimum thickness is less than specified:
–
Change the rear brake linings.
700491-01
x
–
Remove the rear wheel.
–
Remove the lock washer
–
Remove screw
700492-01
–
Remove the brake linings.
–
Clean brake caliper and brake caliper support.
700493-01
x
–
Check the brake discs. (
≥ 1 mm (≥ 0.04 in)
x
(
(
p. 45)
x
.
.
p. 36)
.
p. 43)
42
Advertisement
Table of Contents
