Advertisement
Basic Operation
Before inserting your document,
1
turn crank handle clockwise one
revolution to ensure film is wrinkle-free.
Insert and align document on feed tray.
Extend the document underneath the
paddle on the feed tray and completely
into the cartridge opening until it touches
the film/adhesive.
Gently guide the document
2
forward while turning the crank
handle clockwise.
trimming operation, trim off any excess
material on the leading edge of the output
(with cut blade) before advancing completely
through the dispenser.
Trim to desired length using
3
the cut blade at the roller exit.
Apply downward pressure on the orange
blade holder and slide to the left or
right.
TIP To save a later trimming operation,
turn the crank to advanced the document
until the leading edge is aligned with the
upper blade bar supporting the cut blade.
Trim excess material from the leading edge of
the document. Continued to crank document
through machine and trim when finished.
How to remove document from adhesive backing
TIP: To save a later
Proper Technique
•
Remove the protective clear mask layer
and discard.
•
Always remove the liner from the media as
shown.
Advertisement
