Table of Contents
Advertisement
Step 1:
• Pull back on the paddle so that it is
in the "up" position.
• Insert a document so the leading edge is
under the paddle. The document should
extend past the edge of the paddle
1-2 inches (2.5-5cm).
Note: The side of the document which is face
down will have adhesive applied when using
1 Side Laminate/1 Side Mounting Adhesive.
• Align the document parallel to the
edge of the feeder tray.
How to remove document from adhesive
B A S I C O P E R A T I O N
Step 2:
• Push forward on the paddle to lock
the document in place.
• Ensure that the leading edge of the
document is adhered down evenly.
If necessary, slide your fingers across
the leading edge to secure it in lace.
• Turn the handle clockwise to advance
the document through the machine.
Step 3:
• Trim the document by pressing down
on the blade holder and sliding it in
either direction.
Note: As the document exits the machine,
you may wish to trim the leading edge.
This will avoid a later trimming operation.
Proper Technique
• Remove the protective clear mask layer
and discard.
• Always remove the liner from the
media as shown.
Advertisement
Table of Contents
