Basic Operation - Xyron XM2500 User Manual

Basic Operation

Step 1:
•
Pull back on the paddle so that it is in
the "up" position.
•
Insert a document so the leading
edge is under the paddle. The docu-
ment should extend past the edge of
the paddle 1-2 inches (2.5-5cm).
Note: The side of the document which is
face down will have adhesive applied when
using 1 Side Laminate/1 Side Mounting
Adhesive.
•
Align the document parallel to the
edge of the feeder tray.
How to remove document from adhesive backing
Step 2:
•
Push forward on the paddle to lock
the document in place.
•
Ensure that the leading edge of the
document is adhered down evenly.
If necessary slide your fingers across
the leading edge to secure it in
place.
•
Turn the handle clockwise to advance
the document through the machine.
Step 3:
•
Trim the document by pressing down on
the blade holder and sliding it in either
direction.
Note: As the document exits the machine, you
may wish to trim the leading edge. This will avoid
a later trimming operation.
Proper Technique
•
Remove the protective clear mask layer
and discard.
•
Always remove the liner from the media as
shown.