Raymarine SPX 10 Installation Manual page 40

32
To connect SeaTalk
WARNING: Use correct fuse
The fuse supplying the SeaTalk
SPX SmartPilot
• Connect the SeaTalk
terminal on the SPX.
Note:
In installations where the SeaTalk
ning an NMEA 2000-compliant system, the SeaTalk
the SPX SmartPilot should be moved to the OFF position. Refer to SeaTalk
ual for more information on connectivity, including connection to NMEA equipment.
Course computer
OFF
ng
ng
system MUST be rated at 5A or less.
ng
cable, supplied with the SPX core pack, to the SeaTalk
POWER
ON
NMEA
FAULT FAULT
cabling
ng
backbone is powered separately, or if you are run-
ng
switch above the SeaTalk
Raymarine Limited
MADE IN HUNGARY
SLEEP
12V
FLUXGATE RUDDER
ng
ng
Reference Man-
24V
CLUTCH
ng
terminal on
PO
D10458-1