Using Application Builder - National Instruments FieldPoint FP-2000 User Manual

Chapter 5 LabVIEW RT Programming

Using Application Builder

FP-2000/2010/2015 User Manual
RT Engine applications and/or host PC applications when you start up your
host PC.
For example, create a shortcut with the following shortcut target:
c:\mybuiltapp.exe -target 127.127.44.108 –quithost
To disable the Select Target Platform dialog box, specify a target, such
as the IP address of the FP-20xx, in the command line argument of your
built application using
c:\mybuiltapp_rtengine.exe -target 127.127.44.108
or
c:\mybuiltapp_host.exe -target host
To disconnect the host PC from the RT Engine after all applications are
downloaded, use
-quithost
c:\mybuiltapp_rtengine.exe -target 127.127.44.108
-quithost
When you target LabVIEW RT to your FP-20xx, use the Application
Builder to embed LabVIEW RT applications on your FP-20xx.
Complete the following steps to embed LabVIEW RT applications on your
FP-20xx using the Application Builder:
1. Target LabVIEW RT to your FP-20xx. Refer to the
LabVIEW RT to the FP-20xx
2. Open a new VI.
. For example,
-target
. For example,
section for more information.
5-8
Targeting
ni.com