Source Files And Vi Settings Tabs; Application Settings And Installer Settings Tabs; Launching Embedded Applications At Startup - National Instruments FieldPoint FP-2000 User Manual

Chapter 5 LabVIEW RT Programming
Caution Do not add the file
The serial port driver is installed on the FP-20xx with the RT Engine. Manually adding
serpdrv
LabVIEW RT Engine on the FP-20xx.

Launching Embedded Applications at Startup

FP-2000/2010/2015 User Manual
If you select Small target with external file for subVIs in the Build
Options pane, you cannot change the LLB for other files path because this
path is determined from the Application Path setting in Network
Options. Refer to the LabVIEW Help for more information about the Small
target with external file for subVIs option. Refer to the
section for more information about accessing and using Network Options.

Source Files and VI Settings Tabs

Use the Source Files and VI Settings tabs the same way you do to build a
LabVIEW RT application when LabVIEW RT is targeted to the host PC.
Refer to the LabVIEW Help for more information about the Source Files
and VI Settings tabs.
serpdrv
to your application adds the Windows driver, which is not compatible with the

Application Settings and Installer Settings Tabs

The Application Settings and Installer Settings tabs are disabled when
you target LabVIEW RT to the FP-20xx because these settings do not apply
to applications embedded on the controller.
The RT Engine can launch your embedded application each time you start
up your FP-20xx. Complete the following steps to launch your embedded
application each time the FP-20xx starts up:
1. Target LabVIEW RT to the FP-20xx. Refer to the
RT to the FP-20xx
2. Select Tools»Network Options.
3. Select RT Target: Miscellaneous from the pull-down menu.
4. Select Launch Application at Boot-up.
5. Click OK.
to your application in the Source Files tab.
section for more information.
5-10
Network Options
Targeting LabVIEW
ni.com