Samsung SCX-5315F Series Service Manual page 56

Error Status Check
Jam 2 at 1. Then paper is not drawn in because of the
stack of papers in the Out tray.
face-down
2. Does it curl while coming out?
tray
Clutch error 1. Check the spring of solenoid
2. Check the armature assembly/cushion
3. Electrical check
High volt- 1. Check the terminal output voltage
age error
2. Check HVPS
Feeding Does the Plate-knockup prevent the paper
loading?
obstacles
Skew Is the Guide adjust set to the paper
width?
Stacking 1. Took out the Stacker extender to support long
papers?
2. Stacked too many papers more than Stacker
can hold?
Engine Check CBF Harness_CN7.
(Main PBA to LSU)
Error
Document Document is not picked up(in ADF).
Jam
Document is stopped after it has fed into the
ADF.
Does it curl while coming out?
Samsung Electronics
Solution
1. Load recommended quantity of papers
2. Open the Cover Front and check whether roller or
spring, which are related to paper out, is not out of posi-
tion. If so, re-locate or replace.
1. Check whether the spring is expanded or not.
2. Check armature is well installed. It may be unstable
assemble.
3. Remove the Main PBA.
1. Remove the Toner cartridge and open the cover and
press cover open switch lever and measure the voltage
with high voltage probe and sending printing data. If the
voltage is normal, change the toner cartridge.
2. Disassemble the left side cover, and check HV of the sol-
der side of HVPS and change it.
MPF :
Turn the power off and on. Open and close the Side cover
to return to the original state.
Cassette :
Adjust Guide to fit the paper width.
Fit the paper width using the Guide adjust.
1. Use extender as per the paper length.
2. The Face-up stacker normally can hold 100 pages when
using 75g/m2, however, stacking capacity can be lowered
depending on the type of papers.
Refer to troubleshooring "ENGINE ERROR".
1. Check document is well stocked in ADF.
2. Check whether document was been fastened together
by staple or clip.
3. Load recommended quantity of papers.
1. Check whether the Reg. sensor is working or not.
2. Check whether the Feed Roller is working or not.
1. Check the Open Cover whether there are bosses.
2. Check the ADF ass'y is well assemble.
Troubleshooting
4-35