Samsung SCX-5315F Series Service Manual page 34

DOS Command mode
This method is just for Parallel Port. Connect to PC with Parallel cable and enter DOS Command to upgrade
the Firmware.
< Method >
a). You will need the following files:- down.bat, down_com.bin, fprt.exe, and "Rom File": this is the firmware file to be loaded
into the printer. Save the files in the same folder, close to the root of C;, e.g. C\TEMP
b). At a DOS prompt, input one of the commands shown below and press the enter key. The file will then be sent automatically to
the printer.
c) There are two commands use the correct one depending on the printer status.
* when the printer is in the user mode and is in the normal ready condition: down "rom file"
* When the product is been placed in the upgrade mode (TECH MODE → MAINTENANCE → FLASH UPGRADE → LOCAL)
fprt "rom file"
d) Do not turn off the power while the upgrade is in process."
4-4-7-2 Remote FAX
This function uses one fax machine already loaded with the latest firmware to upgrade one or more other
remote machines of the same type using the telephone network.
< Method >
1. Operate a fax with the latest firmware to prepare it to send the upgrade. (TECH MODE MAINTENANCE
FLASH UPGRADE REMOTE)
2. Input the telephone number of the fax machine to be upgraded. (Several faxes can be upgrade at the same
time. In this case, enter the telephone number for each machine.)
3. Then press the enter button, this will send the firmware file by calling to the each of the selected fax
machines in turn. (Around 10~15 minutes is needed to send the file to each machine.)
< Caution >
1. The sending and receiving fax machines must be the same model.
2. A sending fax must be set up as ECM mode, and the receiving machine memory must be set up as 100%.
If not the upgrade will fail."
4-4-8 Identify Sale Date(Only SCX-5315F)
This function confirms the date that the consumer first uses the product. The date stored is the date of the first
scan or first print whichever operation the user carries out first.
This information is retained even after a memory delete (Clear All Memory).
< Method >
Press MENU, #, 1, 9, 3, # in sequence. The Firmware version is displayed on the LCD.
Press 1( in the number keypad) : The LCD display shows "Updated date"
Press 2( in the number keypad) : The LCD display shows "Product first use date"
Samsung Electronics
Troubleshooting
4-13