Specifications; Systems - Toro Titan Z4800 Operator's Manual

the deck is raised from the ground and when moved
back, towards the operator it is lowered toward the
ground. Only adjust the height of cut while machine is
not moving.
Hour Meter
Located on the control panel.
The hour meter is connected to a pressure switch
installed in the engine block and it records the number
of hours that the engine has run (Figure 5). If the
ignition switch is left on without engine running, hour
meter will not run.
Note: This switch is not a low oil sensor and will not
alert the operator if the engine oil is low.

Specifications

Systems

Engine
• Engine Specifications: See your Engine Owner's
Manual
• RPM: Full Speed: 3600 ±75 (max) RPM (No Load)
Idle: 1750 (min) RPM
Fuel System
• Capacity: 4.0 gal. (15.1 L)
• Type of Fuel: Regular unleaded gasoline, 87 octane
or higher.
• Fuel Filter: Kohler P/N 24 050 10
• Fuel Shut-Off Valve: 1/4 turn increments ("ON",
"OFF")
Electrical System
• Charging System: Flywheel Alternator
• Charging Capacity: 15 amps
• Battery Type: BCI Group U1
• Battery Voltage: 12 Volt
• Polarity: Negative Ground
• Fuses: One 25 amp, one 20 amp; one 15 amp blade
type
• Diode: TVS
Safety Interlock System
• PTO must be disengaged, brake engaged, and
motion control levers out (neutral lock) to start
engine. (It is not necessary for the operator to be in
the seat to start the engine.)
• Operator must be in seat when PTO is engaged,
brake is disengaged, or motion control levers are
moved in or engine will stop.
• Engine will stop if either the left, the right, or both
levers are moved from neutral lock position while
brake is engaged.
Operator Controls
• Steering and Motion Control:
Note: Motion control levers are adjustable to two
heights.
– Separate levers, on each side of the console,
control speed and direction of travel of the
respective drive wheels.
– Steering is controlled by varying the position of
the levers relative to each other.
– Moving motion control levers outward (in slots)
locks the drive system in neutral.
• PTO Engagement Switch: Engages electric clutch
(to drive belt) which engages mower blades.
• Parking Brake Lever: Engages parking brake.
• Deck Height Adjustment Pin: Sets cutting height
to desired position.
• Deck Lift Assist Lever: Foot pedal that assists in
raising the deck.
Seat
• Type: Standard seat with high back, foam padded
with spring suspension and armrests.
• Mounting: Hinged to tilt up for access to hydraulic
pumps, battery and other components. Held in tilted
position with lanyard. Adjustable fore and aft seat
track.
• Armrests: Standard–foam padded flip-up adjustable
height armrests.
• Seat Safety Switch: Incorporated into the Safety
Interlock System.
Hydrostatic Ground Drive System
• Hydrostatic Pumps: Two Hydro Gear ZT2800
Integrated drive systems.
• Hydraulic Oil Type: Use Mobil 1 15W-50 Synthetic
motor oil.
• Speeds:
– 0-7.0 mph (11.3 km/hr) forward.
– 0-5.0 mph (8.0 km/hr) reverse.
• Drive wheel releases, located on left and right sides
of engine deck, allow machine to be moved when the
engine is not running and brake is off.
14