Ac Power And Backup Battery - Honeywell LYNXR Installation And Setup Manual

Lynxr series

Hide thumbs Also See for LYNXR:

Installation and setup gude (72 pages)

Table Of Contents

Table of Contents

The system is powered by a 9VAC, 15VA Plug-in Transformer,

Canada). Refer to the wiring table below for wire gauge and length.

Use only the provided ADEMCO

1332/1332X10 or 1332CN Transformer

Wiring to the AC Transformer must not exceed 300 feet using 16-gauge wire. The voltage reading between

terminals 15 and 16 of the control must not fall below 9.00VAC.

Do not plug the transformer into the AC outlet until after all wiring connections have been made.

Backup battery. In the event of an AC power loss, the system is supported by a long life backup battery that

is supervised for connection and for low voltage conditions. If the battery is missing, or a low battery condition

is detected, a "low battery" message is displayed and a report is sent to the central station. In addition, the

system will beep once every 45 seconds to audibly indicate a low battery condition (press any key to stop the

beeping).

AC Power and Rechargeable Backup Battery

Connecting AC Power and backup battery

1. Connect wires from the 1332/1332X10 (1332CN in

Canada) AC Transformer to terminals 15 and 16 as

shown in the wiring diagram.

2. Remove battery retainer.

3. Peel the backing from tape on the back plate.

4. Insert battery pack into back plate.

5. Install battery retainer.

6. Connect battery connector to receptacle on

terminal block PC board.

7. After all wiring connections have been made, snap

the front assembly to the back plate and plug the

transformer into a 24-hour, 110VAC unswitched

outlet.

Note:

Rechargeable batteries may take up to 48-hours to

fully charge. The "LOW BAT" message should clear

within four hours or by entering Test Mode.

Ensure the cover is snapped closed prior to applying AC power.

WWW.DIYALARMFORUM.COM