The Conference Settings - TANDBERG Codec C90 Administrator's Manual

TANDBERG Codec C90 and Profiles using C90
Contents Contents Introduction Introduction

The Conference settings

Conference [1..1] IncomingMultisiteCall Mode
Set the incoming Multisite call mode.
Value space: <Allow/Deny>
Allow: Accept incoming calls to an already active call/conference. The incoming call will be added to
the MCU conference.
Deny: The system will not accept incoming calls when you are in a call. The calling side will receive a
busy signal.
Example: Conference 1 IncomingMultisiteCall Mode: Allow
Conference [1..1] AutoAnswer Mode
Set the AutoAnswer mode.
Value space: <On/Off>
On: Enable AutoAnswer to let the system automatically answer all incoming calls.
Off: The incoming calls must be answered manually by pressing the OK key or the green Call key on
the remote control.
Example: Conference 1 AutoAnswer Mode: Off
Conference [1..1] AutoAnswer Mute
The AutoAnswer Mute setting determines whether the microphone is muted when an incoming call is
automatically answered. NOTE! Requires the AutoAnswer Mode to be enabled.
Value space: <On/Off>
On: The incoming call will be muted when automatically answered.
Off: The incoming call will not be muted.
Example: Conference 1 AutoAnswer Mute: Off
Conference [1..1] AutoAnswer Delay
Define how long (in seconds) an incoming call has to wait before it is answered automatically by the
system. NOTE! Requires the AutoAnswer Mode to be enabled.
Value space: <0..50>
Range: 0-50 seconds
Example: Conference 1 AutoAnswer Delay: 0
D14635.03—MAY 2010
Advanced config.
Advanced configuration Advanced configuration Password protection Password protection About monitors About monitors Audio matters Audio matters
The Conference settings,
cont...
Conference [1..1] MicUnmuteOnDisconnect
The MicUnmuteOnDisconnect setting determines if the microphones should be automatically unmuted
when all calls are disconnected. In a meeting room or other shared resource this could be done to prepare
the system for the next user.
Value space: <On/Off>
On: Un-mute the microphones after the call is disconnected.
Off: If muted, let the microphones remain muted after the call is disconnected.
Example: Conference 1 MicUnmuteOnDisconnect: On
Conference [1..1] DoNotDisturb Mode
The Do Not Disturb setting determines whether or not there should be an alert on incoming calls.
Value space: <On/Off>
On: All incoming calls will be rejected, with no alert. The calling side will receive a busy signal when
trying to call the codec. A message will display on screen, telling that Do not disturb is turned on,
together with an option to turn off the Do not disturb. When turning off the Do not disturb mode you will
see a list of the calls that have been rejected.
Off: The incoming calls will be alerted.
Example: DoNotDisturb Mode: Off
Conference [1..1] FarEndControl Mode
Lets you decide if the remote side (far end) should be allowed to select your video sources and control
your local camera (pan, tilt, zoom).
Value space: <On/Off>
On: Allows the far end to be able to select your video sources and control your local camera (pan, tilt,
zoom). You will still be able to control your camera and select your video sources as normal.
Off: Do not allow the far end to select your video sources or to control your local camera (pan, tilt,
zoom).
Example: Conference 1 FarEndControl Mode: On
Conference [1..1] FarEndControl SignalCapability
Set the far end control (H.224) signal capability mode.
Value space: <On/Off>
On: Enable the far end control signal capability.
Off: Disable the far end control signal capability.
Example: Conference 1 FarEndControl SignalCapability: On
16
Administrator guide
Appendices Appendices Contact us Contact us
www.tandberg.com