The Camera Settings - TANDBERG Codec C90 Administrator's Manual

TANDBERG Codec C90 and Profiles using C90
Contents Contents Introduction Introduction

The Camera settings

Cameras PowerLine Frequency
Applies to cameras supporting PowerLine frequency anti-flickering, i.e TANDBERG PrecisionHD 1080p
cameras.
Value space: <Auto/50Hz/60Hz>
Auto: Enable power frequency auto detection in the camera.
50Hz/60Hz: Set to 50Hz or 60Hz.
Example: Cameras PowerLine Frequency: Auto
Cameras Camera [1..7] Brightness Mode
Set the camera brightness mode.
Value space: <Auto/Manual>
Auto: The camera brightness is automatically adjusted by the system.
Manual: Enable manual control of the camera brightness, e.g. the level of the brightness level setting
will be used for the camera.
Example: Cameras Camera 1 Brightness Mode: Auto
Cameras Camera [1..7] Brightness Level
Set the brightness level. NOTE! Requires the Camera Brightness Mode to be set to Manual.
Value space: <1..31>
Range: Select a value from 1 to 31.
Example: Cameras Camera 1 Brightness Level: 1
Cameras Camera [1..7] Brightness Gradient
This setting is hidden, and applies to TANDBERG Telepresence T1/T3.
Cameras Camera [1..7] Whitebalance Mode
Set the camera whitebalance mode.
Value space: <Auto/Manual>
Auto: The camera will continuously adjust the whitebalance depending on the camera view.
Manual: Enable manual control of the camera whitebalance, e.g. the level of the whitebalance level
setting will be used for the camera.
Example: Cameras Camera 1 Whitebalance Mode: auto
D14635.03—MAY 2010
Advanced config.
Advanced configuration Advanced configuration Password protection Password protection About monitors About monitors Audio matters Audio matters
The Camera settings,
cont...
Cameras Camera [1..7] Whitebalance Level
Set the whitebalance level. NOTE! Requires the Camera Whitebalance Mode to be set to Manual.
Value space: <1..16>
Range: Select a value from 1 to 16.
Example: Cameras Camera 1 Whitebalance Level: 1
Cameras Camera [1..7] Focus Mode
Set the camera focus mode.
Value space: <Auto/Manual>
Auto: The focus is automatically adjusted by the system throughout the call. When moving the camera,
the system will use auto focus for a few seconds to set the right focus of the new camera position.
After a few seconds auto focus is turned off to prevent continuous focus adjustments of the camera.
Manual: Turn the autofocus off and adjust the camera focus manually.
Example: Cameras Camera 1 Focus Mode: Auto
Cameras Camera [1..7] Backlight
The backlight functionality compensates for lights shining directly at the camera (usually the sun entering
the window) to avoid a too dark image from the room.
Value space: <On/Off>
On: Turn on the camera backlight.
Off: Turn off the camera backlight.
Example: Cameras Camera 1 Backlight: Off
Cameras Camera [1..7] Mirror
With Mirror mode (horizontal flip) you can mirror the image on screen.
Value space: <Auto/On/Off>
Auto: When the camera is placed upside down the image is automatically mirrored. Use this setting
with cameras that can be mounted upside down, and that can auto detect that the camera is mounted
upside down.
On: See the selfview in mirror mode, e.g. the selfview is reversed and the experience of selfview is as
seeing yourself in a mirror.
Off: See the selfview in normal mode, e.g. the experience of selfview is as seeing yourself as other
people see you.
Example: Cameras Camera 1 Mirror: Off
14
Administrator guide
Appendices Appendices Contact us Contact us
www.tandberg.com