Visual Guidance Settings - Uniden iGO50 Owner's Manual

5.3.7 Visual guidance settings

Settings related to guidance on the map screen can be adjusted here.
Select which Places to show on the map while navigating.
Too many Places make the map crowded so it is a good idea
too keep as few of them on the map as possible. For this,
you have the possibility to save different Place visibility sets.
You have the following possibilities:
• Tap the checkbox to show or hide the Place category.
• Tap the name of the Place category to open the list of its
subcategories.
• Tap
to load a previously saved one. Here you can also revert to
the default visibility settings.
The data fields in the corner of the Map screen can be
customised. Tap this button and select the values you want to
see. The values can be different when you navigate a route
from when you are just cruising without a given destination.
You can select general trip data like your current speed or the
altitude, or route data related to your final destination or the
next waypoint on your route.
If you are approaching a motorway exit or a complex
intersection and the needed information exists, the map is
replaced with a 3D view of the junction. You can turn this
feature on or let the map be displayed for the whole route.
Whenever adequate information is available, lane information
similar to the real ones on road signs above the road is
displayed at the top of the map. You can turn this feature on
or off.
to save the current Place visibility set or
Page 113