Card Fan Problems; Drive Problems - Dell Precision Workstation 370 User's & Service Manual

Fill out the Diagnostics Checklist
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in
the Product Information Guide.
Check the card seating and cable —
1. Turn off the computer and devices, disconnect them from their electrical outlets, wait 10 to 20 seconds,
and then open the computer
2. Ensure that each card is firmly seated in its connector. Reseat any loose cards.
3. Ensure that all cables are firmly connected to their corresponding connectors on the cards. If any cables
appear loose, reconnect them.
For instructions on which cables should be attached to specific connectors on a card, see the card's
documentation.
4. Close the computer cover
on.
Test the graphics card —
1. Turn off the computer and devices, disconnect them from their electrical outlets, wait 10 to 20 seconds,
and then open the computer cover.
2. Remove all cards except the graphics card. See
If your primary hard drive is connected to a drive controller card and not to one of the system board
IDE connectors, leave the drive controller card installed in the computer.
3. Close the computer
on.
4. Run the Dell Diagnostics.
Test the cards —
1. Turn off the computer and devices, disconnect them from their electrical outlets, wait 10 to 20 seconds,
and then open the computer cover.
2. Reinstall one of the cards that you removed previously. See
3. Close the computer
on.
4. Run the Dell Diagnostics.
If any of the tests fail, the card you just reinstalled is faulty and needs to be replaced.
5. Repeat this process until you have reinstalled all cards.

Card Fan Problems

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the
Product Information Guide.
Check the cable connections —
on the system board (for the mini-tower computer see
see "System Board Components").

Drive Problems

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in
the Product Information Guide.
as you complete these checks.
cover.
reconnect the computer and devices to electrical outlets, and then turn them
cover, reconnect the computer and devices to electrical outlets, and then turn them
cover, reconnect the computer and devices to electrical outlets, and then turn them
Make sure the card fan cable is connected firmly to the card fan connector
"Removing a PCI Card."
Installing a PCI
"System Board Components" for the desktop computer,
Card.