Lan - D-Link DSL-2650U User Manual

DSL-2650U 3G/ADSL/Ethernet Router
with Wi-Fi and Built-in Switch
User Manual

LAN

To configure the router's local interface, proceed to the Net / LAN page.
If needed, edit the basic parameters of the local interface.
Parameter
IP Address
Netmask
IGMP snooping
When needed settings are configured, click the Save button.
In the Static DHCP section, you can specify MAC address and IP address pairs (set a fixed IP
address in the local area network for a device with a certain MAC address). The router assigns IP
addresses in accordance with the specified pairs only when the DHCP server is enabled (in the
DHCP server section, in the Mode drop-down list, the Enable value is selected).
Figure 67. The page for configuring the local interface.
The IP address of the router in the local subnet. By default, the
following value is specified: 192.168.1.1.
The mask of the local subnet. By default, the following value is
specified: 255.255.255.0.
The IGMP snooping function provides management of multicast
traffic in the LAN. Select the needed choice of the radio button:
Blocking: the router does not let multicast traffic pass to the LAN.
Standard: the router lets multicast traffic pass to the LAN devices
which request such traffic. Recommended for better performance of
the LAN.
Off: the router lets multicast traffic pass to all devices from the
LAN. Default value.
Page 76 of 139
Configuring via Web-based Interface
Description