Pptp (Point-To-Point Tunneling Protocol) - Encore EN2HWI-N3 User Manual

 Maximum Idle Time: This is for the Internet connection is maintained during inactivity. If
the application is inactive for certain time designated here the internet connection will be
automatically dropped.

PPTP (Point-to-Point Tunneling Protocol)

PPTP uses a virtual private network to connect to your ISP. This method of connection
requires you to enter a username and password (provided by your ISP) to gain access to
the Internet. The supported authentication protocols are PAP and CHAP.
 Address Mode: PPTP can be used with a dynamic or static IP address. If you select the
Dynamic IP radio button, then the IIP address in the next field is not required. However,
if you select the Static IP radio button, then the IP address in the next field is required.
 PPTP IP Address: Enter the IP address
 PPTP Subnet Mask: Enter the subnet Mask for the IP address.
 PPTP Gateway IP Address: Enter the IP address of the PPTP gateway.
 PPTP Server IP Address: Enter the PPTP Server's IP address if it is different from the
default gateway.
 Username: Enter the user name which is provided by your ISP.
 Password: Enter the password which is provided by your ISP.
 Verify Password: Enter the password again for verification
23
www.encore-usa.com