Table of Contents
Advertisement
Instrument Lights - On the 378, the INSTRUMENT LIGHTS
switch is used to activate the instrument lights on the
dash. It has a two position switch that provides bright
and dim lights.
Navigation & Anchor Lights - Moving the NAV/ANCHOR
LIGHTS switch towards the NAV position activates the
bow lights and the all-around light. Move the switch to the
ANC position to activate the all-around light. The center
switch position is OFF.
Platform Lights - The PLATFORM LIGHTS switch is used
to activate the swim platform lights.
Trim Tabs - The boat is equipped with electric-hydraulic
trim tabs, the trim tabs are controlled by the TRIM TAB
switches. Refer to Section E-7 - Trim Tabs for more infor-
mation.
Windlass - The WINDLASS switch activates the wind-
lass. Refer to the Section M-12 in this manual and the
manufacturer's literature for additional information.
Wipers - The WIPERS switch activates the windshield
wipers. The wipers will self park to port.
B. Installation of Additional 12 Volt Equipment
Accessories may be added to the boat by wiring directly
to the cabin panel. Non-factory installed 12 volt acces-
sory equipment can be connected to the "ACC" switch on
the dash.
Be sure to provide proper fuse or circuit breaker
protection for all 12 volt equipment that is installed.
DO NOT overload the accessory circuitry by in-
stalling too much additional 12 volt equipment.
C. Interior Equipment
Cabin equipment is protected by the 12 volt DC cabin
panel on the 378 Vista™. Cabin equipment information is
listed as follows:
CO Monitor - The CO monitors are protected by a circuit
breaker in the cabin panel.
Cabin Lights - To turn the overhead lights on, use the
corresponding ON/OFF switch located on cabin lights
panel or V-berth switch panel to activate the desired light-
ing.
378 Vista™ Owner's Manual
™
378
Forward Bilge Pump - The forward bilge compartment
can be activated manually by the FWD BILGE breaker
switch.
Any water from the stringers or from other sources within
the cabin will drain into the forward bilge compartment.
The pump is equipped with an automatic float switch
and will operate whenever bilge water rises to a level that
will cause the float to move upward. The water will be
pumped overboard.
Head Compartment Vent/Blower - A blower is installed
in the head compartment. A separate ON-OFF switch is
provided in the head compartment. The head blower is
protected by a circuit breaker on the cabin DC panel.
Pressurized Water - A pressure water pump delivers
water to the faucets, shower, and transom washdown.
The pressure water pump will operate automatically as
long as the FRESH WATER breaker is ON in the 378
Vista™.
Turn the FRESH WATER switch OFF when the water
tank becomes empty, or when water will not be required
for an extended period. The 378 comes standard with
tank monitoring systems to check water levels. Refer
to Section J-1 and J-2 in this manual for additional infor-
mation.
Refrigerators - Circuit breakers are provided on the DC
cabin panel. The refrigerators have a separate ON-OFF
switch. Refer to Section L-1C in this manual and to the
manufacturer's literature for additional information.
Stereo - The stereo has a separate switch on the unit
and is protected by a circuit breaker labeled STEREO/
AMPLIFIER on the 12 volt cabin panel of the 378.
Sump Pump - A sump pump is used to discharge water
from the shower and sink drains overboard. It is installed
on all Vista™ models. The sump pump has a float
switch which will activate the pump when the water level
rises in the sump. This pump is protected by the SUMP
circuit breaker located in the 12 volt cabin panel.
If the boat is equipped with a grey water system, the
water from the shower and sinks is pumped into a hold-
ing tank instead of overboard.
Section H
Page 4
Advertisement
Table of Contents
