Table of Contents
Advertisement
Figure N6: Stern Seating
Cockpit Fill-in Support
Figure N7: Stern Seating & Fill-in Support-Stored
Figure N8: Starboard Cockpit Seat Storage
A fill-in cushion is also provided to extend the cushion
area for such things as sunbathing, napping or overnight
sleeping. Refer to Figures N9 and N10.
378 Vista™ Owner's Manual
™
378
To install fill-in cushion:
1. From its stored position, loosen screw knob on cou-
pler and retract end from holder and swing the cock-
pit fill-in support away from storage position.
2. Extend the support into the fill-in support block un
der the aft stern seat. Re-tighten screw knob cou-
pler.
3. Undo the velcro strap and place the crutch leg per-
pendicular to the deck for support.
4. Place folded cockpit table/fill-in assembly onto the
17" (short) leg which has already been inserted into
the cockpit table floor mount.
5. Unfold cockpit table using the "dog bone" sliding
supports. Simply slide "dog bone" sliding supports
into support positions.
6. Place fill-in cushions on top of the cockpit table/fill-
in support.
To remove the cockpit fill-in cushion simply reverse the
process described above.
Figure N9: Fill-in Cockpit Cushion
Figure N10: Fill-in Support Assembly
The aft cockpit stern seat uses hydraulic hinges. The
hinged cushion allows the aft cockpit cushion to fold up
against the transom. Access to the engine compart-
ment is possible without the removal of the stern seat
cushion. Refer to Figure N11.
Section N
Page 3
Advertisement
Table of Contents
