JVC RX-F10S Instructions Manual page 43

❏ Changing the transmittable signals for operating
a VCR
Set the mode selector to "AUDIO/TV/VCR/STB."
1 Press and hold VCR
2
Press VCR.
3
Enter the manufacturer's code using buttons
1 – 9, and 0.
See "Manufacturers' codes for VCR" on the right.
4 Release VCR .
Now, you can perform the following operation on the VCR.
VCR : Turn on or off the VCR.
After pressing VCR, you can perform the following operations
on the VCR.
CHANNEL +/–: Change the channel numbers on the
VCR.
1 – 9, 0: Select the channel numbers on the VCR.
3:
Start playback.
7:
Stop playback.
8:
Pause playback.
¡:
Fast-wind a tape.
1:
Rewind a tape.
See the instructions supplied with the VCR for details.
5
Try to operate your VCR by pressing VCR
When your VCR turns on or off, you have entered the correct
code.
If more than one code is listed for your brand of VCR, try each
one until the correct one is entered.
.
.
Manufacturers' codes for VCR
Manufacturer Codes
JVC 01
Akai 02, 36
Bell+Howell 03, 16
Blaupunkt 04
CGM 03, 05, 16
Daewoo 34
Digtal 05
Fisher 03, 16
G.E. 06
Grundig 07
Hitachi 08, 09
Loewe 05, 10, 11
Magnavox 04, 05
Mitsubishi 12, 13, 14, 15
Nokia 16
Nordmende 17, 18, 19, 31
Orion 20
Panasonic 21
Philips 05, 22
Phonola 05
Saba 17, 18, 19, 23, 31
Samsung 24, 25
Sanyo 03, 16
Sharp 26, 27
Siemens 07
Sony 28, 29, 30, 35
Telefunken 17, 18, 19, 31, 32
Toshiba 33
Initial setting: 01
Manufacturers' codes are subject to change without
notice. If they are changed, this remote control cannot
operate the equipment.
39