Intermec EasyCoder 501 XP Installation & Operation Manual page 104

Paper,
cont'd.
Tickets with Gap
a
b
c
f
d
e
TICKETS & TAGS
PAPER FEED
DIRECTION
Intermec EasyCoder 501 XP – Installation & Operation Ed. 3
⇐ a ⇒ Web Width:
Maximum .......................... :
Minimum .......................... :
⇐ b ⇒ Copy Length:
Min. length between slots .. :
Max. length between slots .. : depends on DRAM memory size
Under favourable circumstances, a minimum ticket length down to
4 mm (0.16") could be used. It requires the sum of the copy length
(b) and the detection slit height (f) to be larger than 7 mm (0.28"),
that batch printing is used, and that no pull back of the paper is
performed. Intermec does not guarantee that such short labels will
work, but it is up to the user to test this in his unique application.
⇐ c ⇒ Detection Slit Start:
The restriction of the minimum detection slit length must be ob-
served and the slit must not break the inner edge of the web.
⇐ d ⇒ Detection Slit Length:
The length of the detections slit (excluding corner radii) must be:
Minimum .......................... :
⇐ e ⇒ Detection Slit End:
Provided the restrictions of the minimum slit length and slit start
are observed, the distance from the inner edge of the web to the
outer end of the slit (excl. corner radii) may be:
Maximum .......................... :
⇐ f ⇒ Detection Slit Height:
Maximum .......................... :
Recommended ................... :
Minimum .......................... :
Media Type Setup:
• Ticket (w gaps)
Do not allow any perforation to break the edge of the web, as this
may cause the web to split, resulting in a paper jam.
Appendix 2 Media Specifications
120.0 mm (4.72")
25.4 mm (1.00")
8.0 mm (0.32")
5.0 mm (0.20")
50.0 mm (1.97")
21.3 mm (0.83")
1.6 mm (0.06")
1.2 mm (0.05")
103