Toro Super Recycler 20382 Operator's Manual page 5

Setup
Important: Remove and discard the protective
plastic sheet that covers the engine.
1
Assembling and Unfolding the
Handle
No Parts Required
Procedure
WARNING
Assembling and unfolding the handle improperly
can damage the cables, causing an unsafe operating
condition.
• Do not damage the cables when assembling and
unfolding the handle.
• Ensure that the cables are routed to the outside
of the handle.
• If a cable is damaged, contact an Authorized
Service Dealer.
1. Raise the rear of the mower housing to its highest
cutting height setting by moving the 2 rear cutting
height levers all the way forward. Refer to Adjusting
the Cutting Height in the Operation section.
2. Attach the handle ends to the mower housing with
2 washers and 2 handle bolts (Figure 3), but do not
tighten the handle bolts.
1. Washer
2. Handle bolt
G017478
Figure 3
3. Handle end
Important: Route the cables to the outside of
the handle (Figure 3).
3. Rotate the handle rearward (Figure 4).
4. Lock the handle at your desired height. Refer to
Adjusting the Handle Height in the Operation
section.
5. Torque the handle bolts to 120 to 160 in-lb (14 to
17 N-m).
6. Adjust the cutting height. Refer to Adjusting the
Cutting Height.
5
G017479
Figure 4