Logger Features; Ilog Display - Escort iLog User Manual

Logger features

Internal, Internal/External, Two External and Internal/humidity sensor options.
Rear label specifying product code and serial number plus bar coded serial number
according to EAN 128.
Lug (loop on top) to fix logger on wall or other surface as required.
Removable external temperature sensor options (depending on model), with external
sensor connector(s) being located on either side of your logger's case for fast
temperature response.
Display showing last temperature measurement taken plus alarm status (High Alarm /
Low Alarm), or status of the logger. Optional statistics (e.g. highest, lowest, and average)
can be chosen during logger programming.
Start the logger via magnet swipe or pre-program to start at a specific date and time.
Logging interval as low as 1 second per reading and as high as one day (24 hours).
User replaceable battery. To replace the battery, simply remove the three screws located
on the rear of your logger's case. Carefully pull the front half of the logger away from the
back, being careful not to lose the rubber seal located inside the lid, and the three small
seals, located on each screw. Replace the battery and seals in correct position. For
humidity loggers, DO NOT touch the sensors. Seal your logger's case with the three
logger screws.
Note: Stored readings cannot be lost by removing the battery. However if you are
currently logging, or you need the real-time clock to keep time, it is important that you
replace your old battery with a new battery immediately upon removal of the old
battery.

iLog Display

iLog User Guide
5