Figure 3-8. Bilge Pumps - Chris-Craft Lancer 20 Owner's Manual

The bilge pump is normally held in place with clips for easy removal and cleaning. Use care when remov-
ing and/or reinstalling the bilge pump. If you remove the pump for cleaning, after reinstalling perform a
systems test to ensure proper operation.
The bilge pump is protected by a circuit breaker located at the Helm Breaker Panel.
800 GPH Bilge Pump
Should a bilge pump fail to operate, check the fuse and wiring connections. If the pump operates but fails
to discharge water, inspect for clogs or kinks in the discharge line.
If oil is present in the bilge, do not use the bilge pump to discharge the waste. Mop up the
waste and dispose of properly.
Chris-Craft

Figure 3-8. Bilge Pumps

1000 GPH Bilge Pump
Systems
3–11