Ford Focus 2002 Workshop Manual page 3

2002 Focus Workshop Manual
11. Install the oil pump screen cover and tube.
Use a new gasket.
12. Clean and inspect the mounting faces of both the oil pan and the cylinder block. To remove all traces of previous sealant, use solvent to clean the cylinder block and oil pan. Both
surfaces must be flat, clean and dry.
13. NOTE: Install the oil pan within ten minutes after the sealant is applied.
Apply silicone gasket and sealant F6AZ-19562-AA or equivalent Ford specification WSE-M4G323-A6 approximately 3 mm (0.125 In) wide at the oil pan to cylinder block joints
and the crankshaft rear oil seal retainer to cylinder block joints.
14. NOTE: Make sure the press fit tabs are fully engaged in the oil pan gasket channel when installing the oil pan gasket and oil pan.
NOTE: The rear edge of the oil pan must be aligned with the rear face of the cylinder block using a straight edge.
Install the oil pan. Tighten the bolts in the sequence shown.
The stud bolt locations are one and five.
15. CAUTION: Always use new cylinder head bolts.
NOTE: Lubricate the cylinder head bolts with engine oil prior to installation.
Install a new gasket and tighten the cylinder head bolts in the following sequence.
1. Tighten all the bolts in a single sequence to 50 Nm.
2. Back the bolts off one-half turn.
3. Tighten all the bolts in the sequence shown to 50 Nm.
4. Rotate all the bolts in a single sequence an additional 180 degrees, in two steps of 90 degrees each.
16. NOTE: Inspect the valve cover gasket. Install a new gasket if it is cracked, torn, distorted or damaged.
Install the valve cover.
http://www.fordtechservice.dealerconnection.com/pubs/content/~WS2Y/~MUS~LEN/20/S...
Page 3 of 9
6/19/2008