External Device Control - Denon HEOS Link Owner's Manual

Contents

External Device Control

The HEOS Link can tightly integrate with most Denon AVR, Preamps, and
Hi-Fi systems to allow them to operate as if they were one device.
You can configure your HEOS Link to tell the connected device when to
turn on, turn off, select the correct input and adjust volume and mute.
You can adjust specific settings for each of your HEOS Links in your
system:
1
Select the Settings a icon located in the upper left
corner of the main Music menu to display the Settings
menu.
2
Select "My Devices" to display a list of your devices.
3
Select "Control".
4
Select the method which is most appropriate for your
configuration:
Setup Use Troubleshooting
o IR Control
Connect the appropriate IR control cable between your AV receiver or
amplifier and the HEOS Link using the IR direct or IR emitter cable (both
included) depending on the IR control input capabilities of your device.
Your amplifier or
AV receiver
IR
IN OUT
REMOTE
CONTROL
DC12V
5V1A
150mA
MAX.
RESET IR TRIGGER COAXIAL OPTICAL OPTICAL
USB NETWORK
OUT OUT OUT OUT IN
SUB
AC IN
PRE OUT WOOFER LINE IN AUX IN
NOTE
Connecting the IR control cable (IR Direct cable/IR Emitter cable) to the Trigger Out
connector of the HEOS Link incorrectly may break the connected AV receiver, the
amplifier or the IR Emitter cable.
37
Status LED Appendix
Your amplifier or
AV receiver
Remote control sensor
or
DC12V
150mA
MAX.
RESET IR TRIGGER COAXIAL OPTICAL
OUT OUT OUT OUT
SUB
AC IN
PRE OUT WOOFER
5V1A
OPTICAL
USB NETWORK
IN
LINE IN AUX IN